- Paper (depending on quality), min. : 80 – 90 g/m2
- Carton (depending on quality), up to : 600 g/m2
- Corrugated board (Fine), up to : 4 mm
- (*) Admissible undulation: 4% of the sheet width
- Minimal gripper edge : 9.5 mm
Foil Stamping System
- Four servo motor driven foil advancing shafts each individually programmable for short and long foil stepping 99 programmable short pull per shaft
- Each foil advancing shaft is equipped with a holographic foil print mark reading photo sensor.
- Industrial PC holographic foil stamping to print register system with manual register tolerance compensation device.
- Free standing operation console with industrial pc, Pro – Face touch screen and 12 thermometers
- for foil advancing step setting and temperature control with machine pre-heating timer
- Draw type foil roll bracket for loading foil outside at operation side
- Foil lead through bar
- 450 turning bar
Specifications for die cutting:
- Maximum die cutting size: 1040 x 730 mm
- Inner size of chase: 1145 x 755 mm
- Dimensions die cutting plate: 1080 x 736 mm
- Maximum die cutting pressure: 300 T
- Maximum mechanical speed: 7500 cycles/hour
- Foil splitting blade Heating base with 12 heating zone each temperature adjustable individually
- Foil breaking control
- Warning system for remaining foil
- Oil cooled tension control shaft
- Foil separating air blaster with air volume, blasting strength per zone and starting and ending time adjustment
- Thin paper stretching air blaster with air volume, blasting strength per zone and starting and ending time adjustment
- A/C motor driven inverter-controlled brush rollers waste foil ejecting and foil tension system
